![]() ![]() I am not sure if this might cause a problem, and introduce motor hum? Having a remote is important (see background below for why.) I did notice, however, that the wires from the fan itself were solid core, where as the wires from the remote receiver were stranded aluminum. Wiring the remote control receiver was a no brainer.every connection was color coded. I've had an electrician come out and check the wiring, and everything is solid according to him.įrom a wiring standpoint, I used a Harbor Breeze remote control with the fan, which was nicely designed to fit within and work perfectly with the Harbor Breeze fan itself. Cranking the fan up to high speed would drown out the sound of the hum, but then I have the fan noise itself to deal with. The fan produced a very audible motor hum, similar to that described in this question, however strait off of my native power. I have wired both mounts into the ceiling, and tried out a single 52" Harbor Breeze fan in one of them. The room is about 16x27 feet, and it gets pretty hot during spring, summer, and early fall. And of course, sometimes the remote gets lost on the couch, too.I am in the market to buy two large ceiling fans to cycle air within and potentially cool my master bedroom. ![]() Not everyone puts it back in the spot that it should be, either. The fan controls generally include forward, reverse, and speed controls which are slow, medium, and high.Ī fan remote is often the most misplaced accessory when it comes to ceiling fans, because like a tv remote, many people in the home may use it. This remote will control both the fan as well as the light kit that is attached to the fan. Here we have posted a replacement remote. If you know how to use a multimeter to check the circuit, try doing that as well. See if there are any connections that have come loose. Once the power is completely shut off, open up the fan housing and take a look inside. Make sure before you do any work to the internal wiring of the fan, that you shut off power to the fan from the circuit breaker (not just the light switch). You’ll need to open up the fan housing and check the electrical connections. The same goes if there is power and the fan still won’t turn at all. If there is no power coming to the fan lights and there seems to be no power at all, there could be an electrical short within the fan housing. If the fan looks like it’s trying to turn and there’s a bad groaning sound, or smoke, turn the fan off immediately. Try putting it in forward and reverse to see if either mode works. Make sure the switch isn’t in between positions. If the fan won’t turn on and the lights are working, then there is no power to the fan. they need to be set the same way on both the fan and the remote. This can usually be done by checking the dip switches. If the remote is sending a signal, check to see if the fan and the remote are set to the same frequencies. ![]() Is there a light that normally turns on when you are using the remote to send a signal? Is the light still turning on or not doing anything at all? If the light is not coming on then the remote is not sending a signal.Īlso Check: How to use Harbor Breeze ceiling fan remote? If replacing the batteries does not work, check the remote. Replace them, even if you replaced them already recently. The batteries are the most common place to start. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |